General HighDesign Discussions
- Posts: 1
- Joined: Mon Mar 16, 2020 12:39 pm
I am using High Design LT on a Mac. I created a drawing that at 1:1 will need to be printed on a large format printer at an engineering print service. How do I create the right file for this purpose? Perhaps the LT version is not up to this task, if so I will upgrade in order to "publish to PDF".
- Posts: 611
- Joined: Tue Jul 06, 2004 10:52 pm
- Location: California
Are you on R5? If so this advice may not be relevant anymore, but I would set up my sheets and then print them to PDF. Gave great results.