If you would like to see a feature implemented in HighDesign please post your suggestions and requests here.
- Posts: 611
- Joined: Tue Jul 06, 2004 10:52 pm
- Location: California
Nobody gives areas in mm2, but many work in mm for drafting. There really should be an option to have a different unit set for area calculations.
A work around in the meantime is to set the sheet to m to do all the area calcs then set it back, but this is of course a pain when doing revisions.
- Site Admin
- Posts: 532
- Joined: Thu Apr 29, 2004 2:16 pm
- Location: Ilexsoft HQ