Chamfer

If you would like to see a feature implemented in HighDesign please post your suggestions and requests here.
Post Reply
Jonathan Lear
Posts: 11
Joined: Tue Oct 29, 2013 12:44 pm
Location: Bristol, England
Has thanked: 0
Been thanked: 0
Contact:

Chamfer

Post by Jonathan Lear » Sat Feb 08, 2014 12:45 pm

I'm posting these as and when I come across them. Hope this is OK.

The chamfer tool chamfers on the side where both centre points are- not very helpful! This should be to the side of the two lines that you click. I regularly set the chamfer to 0 and chamfer two lines to a right angle- this is very useful but as it is it's hit and miss as to what side it chamfers.

Post Reply