Send to back

If you would like to see a feature implemented in HighDesign please post your suggestions and requests here.
Post Reply
User avatar
Guess Who
Posts: 5
Joined: Mon Feb 14, 2005 4:19 am
Location: Lexington, KY

Send to back

Post by Guess Who »

It would be nice to be able to send an object to back. I often to grayscale hatches and they can partially overlap a perimeter line. Typically I can just move everything over 100', move the hatch back 100', and then copy the linework back 100'. This way the lines are newer than the hatchwork, and thus are on top.

However, send to back would be easier, or am I missing something?

Thanks,

Guess Who

User avatar
alexwhite
Posts: 262
Joined: Tue May 04, 2004 4:45 pm
Location: Indianapolis USA
Contact:

Post by alexwhite »

Look under the Edit menu commands. There are Arragement toosl. Also you could use a specific sheet (exmaple named hatch) to place all your hatching. Then move this sheet under the sheets that you want to be displayed on top
fat guy in a little coat

User avatar
Guess Who
Posts: 5
Joined: Mon Feb 14, 2005 4:19 am
Location: Lexington, KY

Post by Guess Who »

:D What do you know, it was there all along.

Thanks guys,
-Guess Who

Post Reply