fillet tool

If you would like to see a feature implemented in HighDesign please post your suggestions and requests here.
Post Reply
macitect
Posts: 618
Joined: Tue Jul 06, 2004 10:52 pm
Location: California

fillet tool

Post by macitect »

Following a discussion in the general forum here is an official wish:

that the fillet/join/trim tools will be modified to erase the portion of line opposite of the intersection to the portion that is clicked. Perhaps it is worded better by ybalx:

"Back to point on the command, and perhaps this belongs in the wish list forum, but a solution to this problem that would speed up the routine would be to force the break/trim/join routine to cleave off the section opposite the intersection of your selection as a default. Therefore, if you select two lines on the sections that you want to keep, the command action would effect the opposite portions..."

thanks,
macitect

Post Reply