Just a quick hello

This forum is for general and non-support discussion only. Sharing ideas? Networking? Looking for collaboration? This is the right place.
Post Reply
Posts: 19
Joined: Thu Nov 01, 2007 3:13 pm

Just a quick hello

Post by AJUK »

Hi all,

I am new to the forums and thought I would say hi. Although I have owned a license for HD Pro for a while I have only just recently started using it in anger.

I am a structural engineer in the UK and I was using Vectorworks before but because it doesn't work very well on Leopard and I cannot justify upgrading to the new version, I dusted off HD and am now wishing I did it a lot earlier.

Be prepared for some questions as I get to grips with it. :)

Posts: 611
Joined: Tue Jul 06, 2004 10:52 pm
Location: California

Post by macitect »

Welcome aboard!

I think you'll find it straightforward and easy enough, but for any of your questions you'll find that there are many on this board who are ready and willing to help. The tech support is really fantastic too!

Posts: 160
Joined: Fri Nov 10, 2006 4:39 pm
Location: Vancouver

Post by peatle »

Response time from Ilexsoft Tech Support is incredibly quick so use it.

Second only to them is the response from Derek Tech Support ( Macitect )

Post Reply