Offset

General HighDesign Discussions
Post Reply
Jonathan Lear
Posts: 11
Joined: Tue Oct 29, 2013 12:44 pm
Location: Bristol, England
Has thanked: 0
Been thanked: 0
Contact:

Offset

Post by Jonathan Lear » Sun Nov 15, 2015 11:05 am

Is there a way of stopping the offset command joining two offset lines?
Sometimes when two lines are at right angles to each other and they are both offset- they are automatically joined by extending them into another right angle instead of simply offsetting the original lines.

Giovanni
Posts: 41
Joined: Mon May 03, 2004 10:28 am
Location: Ilexsoft HQ
Has thanked: 0
Been thanked: 0

Re: Offset

Post by Giovanni » Thu Nov 19, 2015 10:09 am

Currently there is no way to customize the Offset command.
What you can do is to apply the Offset command to one line, press the "esc" key to terminate the command and repeat the procedure with the other line: this way the two resulting lines are not joined.

Anyway, we consider your question as feature request for future updates.
Giovanni Suraci
ilexsoft - Look Ahead

Post Reply