Re-Install from CD

General HighDesign Discussions
Post Reply
Roy
Posts: 19
Joined: Mon Dec 14, 2009 3:04 pm
Location: Winnebago, IL
Has thanked: 0
Been thanked: 0

Re-Install from CD

Post by Roy » Tue Dec 22, 2009 1:50 pm

Since I also ordered the back-up CD when I purchased HD, can I use this to re-install HD on my machine? I would think that is the intention and the license ID number should be the same. Probably won't receive this till next year.

Just looking for possible solutions since I think some how my initial installation was not done properly.

Still having problems with imported symbols from Auto-Cad dwg files. I import them into a drawing and they appear fine. You can move, rotate, place them. Close this drawing and reopen it and some times the symbols are there and some times they are just boxed X's. Move the cursor over the symbol (boked X) and it shows the name of the symbol. Save and close and then open the drawing again and the symbols may appear just fine.

NOTE: The windows and doors imported from HD function flawlessly every time so I suspect it has some thing to do with transistion from dwg to HD.

thanks


Roy

Post Reply