a little question
Some-one can explain me how you can change the linetypes and the hatches.?
I want to delete all these hatches for wall's, concrete, wood , isolation etc.. as they are not needed in technical drawing because I like to include the defined linetypes from ISO 128 or Din 15T1
and the classic hatches for Iron, cast Iron, steel, copper, alum etc... like in ISO-128 or DIN 6 T2
Or is it possible to create your own set of linetypes and hatches and have a kind of selection like p.e. Set building, set mechanical, ????
General HighDesign Discussions
1 post • Page 1 of 1