fill/hatch vertices

General HighDesign Discussions
Post Reply
Posts: 603
Joined: Tue Jul 06, 2004 10:52 pm
Location: California
Has thanked: 0
Been thanked: 0

fill/hatch vertices

Post by macitect » Tue Mar 04, 2008 9:07 pm

Is there a way to suppress the default behaviour of the fill tool to erase vertices when trying to place 2 of them at the same point?

I understand the benefit of the this behaviour, and I do appreciate it most of the time, but when applying materials to elevations I sometimes like to go around windows and doors (rather than applying a fill to the window or door). This was possible before, but now it is no longer possible because whenever you get back to the first point you can't put another vertex there...

Post Reply