Invisible Rectangle

General HighDesign Discussions
Post Reply
peatle
Posts: 160
Joined: Fri Nov 10, 2006 4:39 pm
Location: Vancouver

Invisible Rectangle

Post by peatle »

I can not draw a rectangle that doesn't disappear when I click to set the end point.

I can use the multisided polygon tool( including four sides ) and it works fine but the regular and inclined rectangle tools don't.

If I click in the area that I placed the ( invisible ) rectangle then the control points appear so the rectangle must be there as well, but not seen.

~ Peter

User avatar
Andrew
Site Admin
Posts: 634
Joined: Thu Apr 29, 2004 2:16 pm
Location: Ilexsoft HQ
Contact:

Post by Andrew »

I would check its attributes by clicking the paint bucket icon on the Properties bar when it is selected. The rectangle was probably created with the Edges property disabled.

peatle
Posts: 160
Joined: Fri Nov 10, 2006 4:39 pm
Location: Vancouver

Post by peatle »

Thanks Andrew ........ that was the problem. I keep forgetting about that 'other' properties bar . wasn't there some plans to change the need for that ???

Peter

Post Reply