folks, I've created symbols, but the insertion point is always dead center. Is there a way to save the symbol with a different insertion reference point, say the lower left corner?
gratzi!
set insertion ref point on a symbol?
-
- Posts: 207
- Joined: Tue Jul 03, 2007 5:14 pm
- Location: Pahoa, Hawai'i. Yes, where the lava is.
When you're in the Symbols dialog box and have selected a symbol from the list, you can then establish the insert point for all symbols used in that session (until restart of HD).
Just move your cursor to the edge or corner of the symbol image and the the pointer will change to a cross. Then you can click and change the insertion point.
I don't believe this default is saved after you close HD and reopen the file... probably should be though.
Just move your cursor to the edge or corner of the symbol image and the the pointer will change to a cross. Then you can click and change the insertion point.
I don't believe this default is saved after you close HD and reopen the file... probably should be though.
fat guy in a little coat